Architectural shingles
Metal roofing
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Boral Shingle Repair: The Paradise Owner’s Guide
Boral shingle repair in Paradise typically runs $450 to $1,400 installed for a partial repair involving genuine Boral-matched shingles, underlayment, and flashing, and we can usually get out to look at it within a day or two of your call. Full re-shingling of a single slope runs higher, from $1,900 to $4,200. Most Paradise owners don’t notice a problem until they’re up on a ladder after a wind event and see curls, missing tabs, or a little pile of mineral grit in the gutter. By then the shingle has been drying out in our high-desert sun for a while, and the repair is more than a spot patch. We’re an independent roofing company and not affiliated with Boral, but we’ve set Boral shingles on plenty of Paradise roofs and know what to look for.
Which Boral Models This Applies To
Boral makes several shingle lines that show up on Paradise homes, and matching matters more than people think. The most common ones you’ll run into around here are Boral’s SteelShake (a stamped-steel shingle engineered to look like cedar shake), Boral’s composite slate and shake products, and the concrete and clay tile lines Boral is known for. Each has different nailing zones and overlapping dimensions, so a patch from the wrong line won’t sit flush no matter how carefully it’s cut.
To identify yours, look for the stamped or printed product name on the back of a loose tab, or check the underside of any shingle that’s already come free. If the label is gone, measure the exposure – the visible height of each course – and the tab width. SteelShake panels have a fixed panel dimension that tells you immediately if it’s the steel line. For the OEM-versus-aftermarket question: with Boral’s metal and composite lines, we recommend genuine Boral replacement pieces whenever the line is still in production, because the profile and finish coat are proprietary and an aftermarket look-alike will always read slightly off in color and shadow. When a line has been discontinued, we’ll be honest about it and talk through the closest match or a re-shingle of the affected slope.
Styles & brands we work with
- Architectural shingles
- Metal roofing
- Tile roofing
- GAF
- Owens Corning
- Flat & low-slope
Signs Your Boral Shingle Repair Is Failing
Here’s what Paradise owners usually spot first, and what’s actually going on underneath:
- Curling or clawing at the tab edges. The sun bakes the top surface while the underside stays cooler, and over time that uneven stress pulls the edges up. Once they curl, wind gets under them and the seal is gone.
- Granule loss in the gutters and at the downspouts. A little grit is normal in the first year. A steady buildup after several seasons means the protective coating is wearing through and the shingle is thinning.
- Missing or lifted panels after a wind event. Boral’s steel and composite panels rely on a specific nailing pattern to hold their wind rating. When a panel lifts, it’s often because a nail was placed high or a seal strip failed, not because the panel itself was bad.
- Cracked or split shingles around flashings and valleys. These are the spots where water concentrates and where the shingle flexes most. Cracks here usually mean the flashing seal has also failed.
- Daylight or dark staining in the attic after rain. That’s the sign the shingle repair has already let water past the underlayment. This one needs attention sooner rather than later.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Paradise, an installed partial Boral shingle repair (matching shingles, new underlayment under the patch, flashing reset where needed) commonly lands between $450 and $1,400. A full re-shingle of a single slope runs $1,900 to $4,200. What drives the number is how much of the deck is exposed once we pull the damaged shingles, whether the flashing needs to be replaced rather than reset, and whether your Boral line is still in production or we’re matching a discontinued one.
We quote parts and labor separately so you can see exactly what you’re paying for. Every roofing job we do is covered by our written 90-Day Done Right Promise – if it’s not done right, one call brings Bill back. We’ll show you the deck photos before we talk money.
DIY or Call Us?
An owner can safely check a few things from the ground: look for grit in the gutters, scan the roof with binoculars for lifted or missing panels, and check the attic after rain for staining. Where DIY goes wrong on Boral shingles is getting on the roof itself. Steel and composite panels are slick, the nailing pattern has to be precise to hold the wind rating, and a bad patch around a flashing can leak for a year before you notice. Roof work at height is genuinely dangerous, and we’d rather you stay off it. If something’s off, call (833) 676-0557 and we’ll come take a look.
FAQs
Boral’s steel and composite lines typically carry a manufacturer’s lifespan measured in decades, but in Paradise’s sun and wind, real-world performance depends heavily on install quality. The nailing pattern and flashing detail matter more than the wrapper. Call (833) 676-0557 for an honest look at yours.
Often yes. A single damaged panel or a small cluster of cracked shingles can usually be swapped or patched without re-shingling the whole slope, as long as the surrounding shingles are still sealing and the flashing is sound. We’ll tell you straight when a repair makes sense and when it’s throwing good money after bad.
A straightforward partial repair is usually a single-day job. If the deck underneath needs repair or the flashing has to be replaced, plan on a bit longer. We’ll give you a realistic window before anyone touches your roof.
We match the specific Boral line – SteelShake, composite slate, or whatever’s on your roof – through our supplier network, and we’re upfront when a line is discontinued and a close match is the best option. Call (833) 676-0557 and we’ll walk through what your roof needs.
Every roofing job we do in Paradise is backed by our written 90-Day Done Right Promise and answered by a live person 24/7. We also install products from GAF, Owens Corning, and CertainTeed, so if your Boral line is discontinued we have real alternatives to talk through. Call (833) 676-0557 to schedule your free estimate – we’ll show you the deck photos before we talk money.
Written by the team at Shepherd & Sons Roofing Paradise, serving Paradise and nearby areas.