Metal roofing
Architectural shingles
Tile roofing
GAF
Owens Corning
Flat & low-slopeFree roof inspection with deck photos before we talk money - GAF and Owens Corning certified installation
Fast, Reliable Metal Roofing Across Henderson
Metal roofing in Henderson is a different job than it is most anywhere else in the country. You’re not fighting snow load or freeze-thaw. You’re fighting UV, monsoon wind, and side yards so tight the panels have to be sized before anyone swings a hammer. We work Henderson roofs constantly, from the master-planned lots in Green Valley and Anthem to the older mid-century houses off Water Street, and we know how much of this work hinges on access and deck condition before a single panel goes up. Call (833) 676-0557 and we’ll come look at the actual site, not just the roof.
Why Shepherd & Sons Roofing Paradise Is Henderson’s Preferred Metal Roofing Company
Henderson homeowners have been burned by storm chasers who show up after a monsoon, quote one number on the phone and another at the door, then vanish. We hear that story every week. Our answer is simple: live people answer the phone around the clock, you get a written estimate with line items, and every roofing job carries our written 90-Day Done Right Promise. If it isn’t done right, one call brings Bill back.
Henderson is dense. A metal re-roof here is a staging problem as much as a roofing problem, and that’s exactly where a local crew earns its keep over an out-of-towner. We plan panel lengths around your setbacks, we talk to the neighbor behind the block wall before tear-off starts, and we keep the driveway and the side yard clean. Estimates are free, and we’ll give you a free second opinion on any written bid you already have. Call (833) 676-0557 to set one up.
Styles & brands we work with
- Architectural shingles
- Metal roofing
- Tile roofing
- GAF
- Owens Corning
- Flat & low-slope
Our Metal Roofing Services in Henderson
Standing Seam Metal Roof
Standing seam is the metal roof most Henderson homeowners picture when they start pricing. On a Henderson re-roof, the panels are usually sized to the run because tight side yards off an Anthem or Green Valley lot don’t leave room for long stock lengths to be maneuvered into place. We detail the drip edge, valleys and penetrations before the panels go on, and we set fasteners to the manufacturer’s pattern, because the nailing earns the wind rating, not the panel wrapper.

Metal Roof Repair
Not every metal roof needs replacing. A lot of Henderson repairs trace back to monsoon microbursts that rip through the valley’s east side and lift field panels or drive rain sideways under them at ridge vents and valley transitions. We inspect the seam and fastener integrity, not just the surface, and we look underneath, because the real leak source is often the baked-out underlayment the panels cover.

Metal Roof Coating
Coating buys time on a metal roof that’s still structurally sound but showing its age in the Henderson sun. Sustained 100°F-plus summers and high-desert UV dry out sealants and fade the finish years faster than in milder climates, and a proper coating resets that clock without a full tear-off. It isn’t right for every roof, and we’ll tell you straight if yours is one that needs replacement instead.

Corrugated Metal & Aluminum Steel Roofing
We also run corrugated and aluminum-steel panels on smaller structures, patios and utility roofs around Henderson. Aluminum handles the desert climate well, and for lower-slope roofs on the older mid-century homes near downtown Henderson it solves detailing problems that a heavier panel profile won’t. Ask about a free second opinion on any written estimate before you commit.
Metal Shingle Roofing
Metal shingle roofing gives you the dimensional look of a shingle roof with a metal core, which fits well on houses where the HOA or an overlay district wants a traditional profile. We install it from the deck up, replacing sun-cracked underlayment before we ever set a panel.
Trusted Brands We Service in Henderson
We install products from GAF, Tamko, Boral and Atlas, and we’ve likely set the exact shingle or panel you’re holding a sample of. We don’t claim to stock parts locally, but we can turn a Henderson re-roof around on a real schedule, and we’ll tell you honestly what lead time to expect on the panel you pick. When a manufacturer’s spec matters, and it does on a desert roof, we’ll show you the install detail before we start.
See the difference
Before
After
Before
After
Before
AfterCommon Metal Roofing Problems We See in Henderson Homes
- Baked-out underlayment beneath the old tile. Because so much of Henderson’s 1990s – 2010s build-out went up as tile-over-wood-frame, a metal retrofit must address the deck, drip edge and flashings, not just the visible cover. The tile itself may look fine while the underlayment underneath is dry and cracking.
- Monsoon microburst damage on the east side. Brief, violent wind-and-rain events lift field panels and drive water sideways under them at ridge vent and valley transitions. That sideways rain stresses fastener and seam integrity, and it’s rarely visible from the ground.
- Compromised edges on tight subdivision lots. Narrow side yards and shared party walls limit staging and panel lengths, and when a crew works around obstructions instead of planning the run, fasteners, starter strip and edge metal get skipped or compromised.
- UV-dried sealants and weathered flashing. Thirty-plus years of desert sun dries out every sealant and flashing on the roof. A metal retrofit has to replace those details, not cover them.
Pricing for Metal Roofing in Henderson, NV
Honest numbers, because a metal roof is a real investment. A typical standing seam metal re-roof on a Henderson home runs roughly $14 to $24 per square foot, and a metal shingle or corrugated system runs about $9 to $17 per square foot. On a 2,000 square foot roof that’s commonly $28,000 to $48,000 for standing seam, before you factor in deck repair. Metal roof coating is much cheaper, usually $2 to $4 a square foot. What drives the price in Henderson specifically is access: tight side yards, staged panels and crane time on a constrained lot add cost that an open-lot job doesn’t carry. Every estimate is free and written with line items, so you know the number before anyone touches your roof. Call (833) 676-0557 for an exact quote.
We Also Serve Cities Near Henderson
We work metal roofing across the valley, including Boulder City, Whitney, Paradise and Enterprise. Because Henderson sits in the heart of the Las Vegas Valley’s extreme desert heat-and-monsoon cycle, the neighboring communities wrestle with the same UV and wind detailing, and our Metal Roofing team can talk you through it. If you’re in another part of the valley, our Metal Roofing in Henderson page is the place to start.
Serving Henderson, NV – Our Local Coverage Area
We serve Henderson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Metal Roofing in Henderson
Yes, on most Henderson homes, but it’s a re-roof over the existing decking, not a simple overlay. The concrete tile comes off, the sun-cracked underlayment and any soft sheathing get replaced, and the new metal goes down on a sound deck. If someone proposes covering over the old tile, walk away. Call (833) 676-0557 and we’ll look at your deck before we quote.
Access is the biggest driver of cost on a tight Henderson lot. Narrow side yards mean panels get staged in the driveway and craned or hand-carried over the fascia, and panel lengths have to be sized to the run. Shared block walls mean neighbors get notified before tear-off. All of that shows up in the quote honestly, so call (833) 676-0557 for a free estimate.
Often yes. Many Henderson master-planned subdivisions and overlay districts have review requirements on roof profile and color, and the older downtown Henderson/Water Street pockets have their own rules. We’ll walk the exterior approval path with you before we order panels. Call (833) 676-0557 to start.
It will, if it’s detailed right. The July-September monsoon pushes brief, violent wind-and-rain events that lift panels and drive rain under them at ridge vents and valley transitions, so the seam and fastener detail matters more than the panel itself. Our crew installs to the manufacturer’s wind spec. Call (833) 676-0557.
A metal roof is measured in squares, and a written quote should tell you how many were counted. We measure the actual roof, add for valleys, hips, penetrations and waste, and give you a line-item estimate. That way you can judge a bid on access and deck work, not panel color alone. Call (833) 676-0557 for a free estimate.
Metal roofing in Henderson asks more of a crew than most jobs because the site, the deck and the monsoon all have a say in how it goes. We’ll show you the deck photos before we talk money, give you a free second opinion on any written estimate, and stand behind the work with our written promise. Call (833) 676-0557 for your free estimate today.
Written by the team at Shepherd & Sons Roofing Paradise.